I'm trying to get Diseqc 1.2 raw commands to work on my Prof 7301, but the motor is not recieving any commands. I'm able to send the commands through other software(SmartDVB), so I know I have the codes right. How do I begin troubleshooting this problem?
Also, how can I use a 22khz switch and a diseqc positioner? Or can I use a positioner and a diseqc 1.1 4x1 switch? Either way will work in my situation.
Using TVSource 4.1.1, trying to decide if I should buy.
Edit: Added screenshot.
Edit #2: Added extended info log
- My server log.
- (7.58 KiB) Downloaded 177 times
- diseqc.jpg (166.17 KiB) Viewed 2081 times
Last edited by dbman
on Mon Apr 16, 2012 5:40 am, edited 1 time in total.