Hi, due to the EPG problems in Windows MCE in the Netherlands (MS just seems to have dropped it), I have to find an alternative to feed my EPG. Someone on a Dutch forum hinted DVB logic can be used to get the EPG data from the TV signal.
I installed this product, started the config page, added a 'EPG+stream' thingie and pushed configure. In the manual, there are a lot of tabs at the top but I only see 'device'. From the manual, I would expect to see my tuners but my page is empty. I have 2 analog tuners that MCE uses. I exit MCE before I start the configuration program.
What do I do wrong?